Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
piston rings to a krausser engine.
#5
Reactie van bezoeker 'Sven-Erik Tiberg', geïmporteerd van het oude forum:

Hi,rnrnSorry for not watching the thread.rnHave found out that the midle and lower ring are the same as for std. engine.rnBut the upper ring are special 1.5 x 4 mm, got a ring from a 95mm bore engine and grinded the gap down to 0.2 mm.rnBut then the next suprise came, the pistion was broken under the upper ring.rnA 4 x 4 x 30 mm piece came lose. Could have happend some years ago as the crankshaft broke into 2 pices riding from swiss and up towards Karsruhe at 170kmh.rnNow I'm searching for a new pistion 94.25 but so far I only got a reply from "MKM-motor" selling a set of pistons. A fellow rider in holland volontered to ask Hobbyis if they could help me with one pistion. rnLooking forward to another season with the krausser racer. Else using a K11LTSE for touring nowdays. And at the moment the weather are more for skiing and skating than beemer riding.rnFirst ride last summer with movies: http://survey.ltu.se/movies/Beemer%5FT%5Fdiesel/rnAnd at the moment: http://survey.ltu.se/movies/new/BWM_modi...nSven-Erik Tiberg rnLulea / Swedenrn
Reply


Messages In This Thread
piston rings to a krausser engine. - by Guest - 01-14-2007, 11:47 PM
piston rings to a krausser engine. - by Guest - 01-16-2007, 09:53 PM
piston rings to a krausser engine. - by Guest - 01-21-2007, 10:57 PM
piston rings to a krausser engine. - by Guest - 03-10-2007, 01:26 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)